Welcome to our resource for MG Car Information.
MG MGF Technical - Front Bumper wont come off!!!!
Hi everyone!!! Eager to get everything ready for MGF 10 i decided to finish all of the bits i never got round to putting on!!.The bright grill kit on my F, did the side vents nearly a year ago, never got round to the front grilles. Tried it and the front bumper wont seem to come off, I have undone the screws at the top under the bonnet lip, and the two bolts behind the indicators Am I missing some more?????? Need to get it done tomorrow as off all day!!!! Cheers Rick |
R P Earle |
yep,behind the wheel arch liner there are two each side, one of each locks into a slotted hole, meaning you can slacken them rather than remove them - which makes refitting easier. Say goodbye to the skin on your knuckles ;-) |
Will Munns |
Rick, Check through the archives, only a few weeks ago I listed what to do bit by bit when I replaced mine. Look under replacement grilles or something like that. Adrian |
Adrian Clifford |
If you are lucky (or unlucky as it goes) you might be like me and only have two of the screws under the wheel arch to worry about as the others have fallen out! |
Sonny Foster |
Adrian's sent me his pictures, but until I put these together as a set of instructions, see Tim Woolcott's instructions on bumper and headlamp removal - it shows all the relevant steps: http://www.mgf.ultimatemg.com/group2/DIY/headlamp_replacement/instructions.htm Good luck! |
Rob Bell |
All, Thanks for the help all done now car all polished and ready to go, not impressed with the Meguairs Polish at all normally avid Autoglym man but decided to try it!!! Bad idea far too much effort and reapplication!!! Wasn't going to use the car till i leave tomorrow but My jeep has turned into the Titanic, has just sprung two leaks one in the F/N/S tyre and one in the fuel line underneath!!!! Oh well will have to wait till nxt week!! See you all either tomorrow or sunday!! Rick |
R P Earle |
Rick, I've been out today and got three complete sets of hood clamp bolts in s/steel, one for you, two for anybody else ?? Adrian |
Adrian Clifford |
This thread was discussed between 13/10/2005 and 14/10/2005
MG MGF Technical index
This thread is from the archive. The Live MG MGF Technical BBS is active now.