MG-Cars.net

Welcome to our resource for MG Car Information.

Recommendations

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG MGB Technical - Poor acceleration below 3000rpm

My 77 MGB GT has developed a reluctance to accelerate below 3,000 rpm.

It's as if it isn't taking the fuel even though the pedal is depressed. Also there a sort of phut, phut, phut sound and a slight stutter a bit like it is missing but not quite.

Once 3,000 rpm is reached is improves slightly but I can't help feeling there something is quite right.


I've had a 1950 balanced engine put in along with electronic ignition and an Aldon performance distributor. Could it be that the carbs are out of balance of that things are bedding in and needed adjusted?

Any advice on the best series of steps to take to investigate much appreciated.

Cheers

Phil
phil dunseath

Phil
I just had the SU HS6 carbs in my 67 GT rebuilt and have the same problem. I've been told that they just need some minor adjustment. So I'd get them looked at.

Donal
Donal

The first step should probably be to check the ignition timing (and related electrical stuff like the plugs). When these seem good, then check carb adjustment. For example, a friend and I recently installed the pertronix electronic ignition in my B (which has a considerably souped up engine), but we didn't have time that day to adequately re-tune the car. It then behaved just as you describe below 2500 to 3000. Subsequently, I suspected the timing was now too retarded, and so advanced it, to about 20 degrees advanced (where it had previously been). This gave probably a 90 percent improvement. I haven't gone back to the carbs yet, where perhaps the remaining "10 percent" can be obtained.
David Cushman

Thanks Guys, I'll have to leave it in to be checked, I don't have the proper tools to do it at, you need a timing light don't you? It seems a bit of a black art to me.
Phil

Mine does the same - the garage claims I need a valve job since I am firing on 3 cylinders. I thought it was sort of OK but it was a bit of a shock to hear. I have to start a thread to see if there are some good ideas.
Ian Dutton

This thread was discussed between 02/09/2001 and 04/09/2001

MG MGB Technical index

This thread is from the archive. The Live MG MGB Technical BBS is active now.