MG-Cars.net

Welcome to our resource for MG Car Information.

Recommendations

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG MGB Technical - Oil Cooler

I want to put an oil cooler on my 79 B. Where do the hoses connect to? What else do I need to buy besides the cooler and hoses/fittings?

Thanks!
Mike D.

Mike,

You haven't got one already? I thought that virtually all Bs (bar the very earliest) had an oil cooler. Look for two hoses of about 1" diameter from the distributor side of the engine, one from the base of the oil filter and one from the engine block near the bellhousing going forwards through the radiator diaphragm. On the rubber cars the oil cooler is hidden below the radiator duct panel and behind the front valance

Some other B series applications don't have oil coolers and you get a different kind of filter housing and a hard line pipe running from the filter to the union at the rear of the block but these are usually only found in Morris Marinas and Sherpa vans.

If you did need to start from scratch you'd need the oil filter base with the 1/2" BSP spigot (12H3272) and associated bolt, sealing ring and filter (Champion C102) as well as the pipes and cooler. You could use a sandwich plate adaptor but I had one of these throw oil all over the engine bay of my BMW so I think you'd be much better doing it properly with the proper MG bits.

Cheers,
Jim
Jim Aitken

My Canadian spec 80 B didn't have a cooler ( and I bought it new so I know it wasn't removed ). It was an easy conversion to do. I actually used a cooler that had the pipes on the bottom, instead of coming up top thru the front pan, so I could drain the cooler when I did my oil changes. It seemed like a good idea at the time but I guess I got lazy and only did that a few times, especially since the changes were not for "old black" oil but for the 3 to 4 month low milage changes.
Dave Pearn

I'm also currently adding an oil cooler to my '75 B and have a question that I can't find covered in the archives. Does anyone know the best way to fit oil cooler pipes through the rubber grommets, and the hose grommets into the radiator shroud? Any advice here would be appreciated.
Bill Powell

Bill,

I drove myself spare fitting the oil hoses through the rad diaphragm. I found that the best way was to coat the hole in the diaphragm and the side of the grommet going through the hole with stacks of vaseline after putting the grommet on the pipe and feeding the pipe through the hole. Put the slit at the top and work anti-clockwise, pushing the grommet through the hole with a small flat-blade screwdriver.

Cheers,
Jim
Jim Aitken

Jim,
Thanks for the advice. I'll give the vaseline a try. I was considering cutting through half of the grommet with a safety blade, but it probably would look messy. Bill
Bill Powell

Vaseline is petroleum jelly and it can perish rubber items such as grommets, a little washing up liquid is a good alternative.
Adam.
Adam

This thread was discussed between 03/09/2001 and 07/09/2001

MG MGB Technical index

This thread is from the archive. The Live MG MGB Technical BBS is active now.