Welcome to our resource for MG Car Information.
MG MGA - Brass Speedo Drive Seal ?
| Does anyone know how the brass speedo drive housing seals into the gearbox. Is it a fibre seal / rubber seal / Copper Washer ? http://mgaguru.com/mgtech/books/spl/spl_tc_f.pdf I "think" it's defunct part number 51K3169 modern comined MGA/MGB geabox gasket sets contain the MGB speedo drive gasket and a fibre washer which I have no idea what it's for as it's too small for the MGA speedo drive. Many Thanks Mark  | 
| Mark Hester | 
| Mark Just had a look at my 1500 gearbox lying in the garage. It's a copper washer. 1.25"OD, 1"ID Steve  | 
| Steve Gyles | 
| Hi Steve, Any idea the size of the copper washer and if that part is used elsewhere under another part number? The several gearbox kit's I have, don't contain any large copper washers. Cheers Mark  | 
| Mark Hester | 
| Mark Assuming we are talking about the same washer I have attached a photo of subject item and the drive unit. Measurements are: 1.253 inches outside diameter 1.068 inches inside diameter 0.041 inches thick Steve ![]()  | 
| Steve Gyles | 
| There is also a rubber shaft seal inside the housing, and is required to work, because the speedo drive resides below oil level in the gearbox. | 
| Barney Gaylord | 
| That looks like the copper washer Steve.. .Many Thanks I also don't have the rubber inside Barney.. Any idea's on what I do to replace this ? Many Thanks Mark  | 
| Mark Hester | 
| Mark Mine does not appear to have one either. Steve  | 
| Steve Gyles | 
| For seal replacement see here: http://mgaguru.com/mgtech/gearbox/gt106.htm | 
| Barney Gaylord | 
| Barney Yes, Makes sense now. Mine is as your photo. Steve  | 
| Steve Gyles | 
This thread was discussed between 21/03/2013 and 22/03/2013
MG MGA index
This thread is from the archive. The Live MG MGA BBS is active now.