MG-Cars.net

Welcome to our resource for MG Car Information.

Recommendations

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG Midget and Sprite Technical - Swapping out a tacho?

Hi all,
Ok, my car midget Mk III 1972 and I have the Powerspark points replacement unit in the dizzy.
The tacho that came with the car is a Smiths RVI 2430/01 with NO external coil on the back of the instrument case.
It WAS working, but has given up the ghost again, so I was wondering as I have access to a Smiths RVC1414/00F (From a late model Rubber Bumper MGBGT)
Can I just simply swap them over?
I have checked the web and found the following from Spiyda
From the Spiyda Website:
If you are fitting an RVC tachometer where there was previously an RVI, ignore the old signal wire and run a new wire from the coil / ecu / electronic ignition as appropriate
(if the old signal wire (usually white) connected to the tacho with a male and female bullet connector, connect them to each other.

Has anyone done this?
Will it work with my proposed RVC 1414/00F tacho?
I've attached a photo of the new tacho id that helps or if anyone can suggest what goes where!
Cheers all ( and Seasons Greetings too_
Col



colin frowen

I had thought about doing this recently.

The original two white wires at the tacho are supplying a pulse to the tacho from the ignition feed to the positive side of the coil. One white wire comes from the ignition switch, loops through the tacho - either internally, or externally - and the other white wire goes to the coil +ve terminal.

When fitting the RVC tacho, you can join these two white wires together, so the ignition coil still gets a feed from the ignition switch. You then need to add a separate pulse wire from the switched (-ve) side of the coil to the pulse connection on the RVC tacho.

The other alternative is to add a new white wire from the ignition switched circuit to the +ve terminal of the ignition coil, then move the existing white wire from the +ve terminal to the -ve terminal of the coil and connect the other end of it to the RVC tacho. The original white wire from ignition switch to tacho would be redundant.

I hope that makes sense.
Dave O'Neill 2

Hi Dave,
Many thanks.
Sadly, I'm a bit thick- so do you know which wire goes to what on the image I posted?
Could I check out the RVC tacho by taking a 12 V + feed and a wire from the coil neg?
Told you I was thick...
Cheers col
colin frowen

'A' is the pulse wire form coil -ve.

'B' is 12v ignition switched feed (green).

'C' is ground/earth.

"Could I check out the RVC tacho by taking a 12 V + feed and a wire from the coil neg?"

Yes, along with an earth wire. You could just hook it up inside the engine bay and see if it works.
Dave O'Neill 2

Hi Dave,
Thanks very much indeed.
Got a few quiet days soon , so will have a crack at it. I'll post a report here .
Thanks again
cheers col
colin frowen

This thread was discussed on 20/12/2019

MG Midget and Sprite Technical index

This thread is from the archive. The Live MG Midget and Sprite Technical BBS is active now.