MG-Cars.net

Welcome to our resource for MG Car Information.

Recommendations

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG Midget and Sprite Technical - Remote Clutch Bleed Nipple

I've been reading archive posts on bleeding the clutch slave as i know it is a pain. There is mention of a good idea in fitting a remote bleed nipple in the engine bay. Has anyone done this and have a list of parts that is needed. I note that there is a kit available in the US but cannot find a UK supplier.
Pete Ottewell

Pete - tried an archive search?
Lots of previous threads, some with pics, describing ways of doing it.
Or just buy one:
http://www.petermayengineering.com/catalogue5.htm#catalogue5
David Smith

Hi - there was also a reference to this in the MASCOT mag - October 2014 and another in January 2007 if that's any use.

Alan
a reid

Wait a few minutes and Lawrence will be along with his ingenious idea - although he is not alone!
Jeremy Tickle

Ah of course Peter May, thanks David.
Pete Ottewell

I did a bit of measuring then had my local motor factor make up a suitable length of copper brake pipe with female fittings on each end - make sure the end to go in the slave cylinder is the correct thread (I don't know the details). I also bought a male/male connector and a bleed nipple. I made a simple metal clip that attaches the pipe to the top o/s bell housing bolt. If I remember correctly, my top fittings are metric because they only had a metric connector in stock at the time.

Bleeding is still a bit of a pig, but not as bad as if you're having to use the bleed point on the slave cylinder.

I also acquired a large (60ml) syringe from the local vet. That allows me to reverse bleed to dislodge reluctant air bubbles. I tried using the syringe as a vacuum to suck the fluid through but that just drew air in where the tube was pushed onto the nipple.

Best of bleeding luck!

Colin

PS - Peter May's will be a whole lot more professional and tidier than my installation! My arrangement went in before I discovered P.M.!
Colin Mee

Dip into your Spridget spares bin.
Rear brake flexible into three way connector. Blank off one port with 3/8unf bolt and copper washer. Affix with 1/4unf bolt through hole in three way to a bracket off the bellhousing bolts. Put a bleed nipple in the vacant port.
Thats basically what I wrote in Mascot.
Alan
www.masckent.org
Alan Anstead

Alan, great that's just what I wanted!
Pete Ottewell

Pete

See:

http://www.mg-cars.net/mg-midget-sprite-technical-bbs/1275-clutch-2015052108495229850.htm

&

http://www.mg-cars.net/mg-midget-sprite-technical-bbs/clutch-slave-renew-or-repair-2015031415394126085.htm


Cheers
Mike
M Wood

Thanks Mike bits on order with the rest of the parts list to re-install engine and gearbox. Bits come to around £15 about half the price of a kit.
Pete Ottewell

This thread was discussed between 21/07/2015 and 26/07/2015

MG Midget and Sprite Technical index

This thread is from the archive. The Live MG Midget and Sprite Technical BBS is active now.